Topic: 'Folding' picture

Is it possible to create the effect of a picture (either layer or slide) folding in half, or unfolding like a card.

I've tried duplicate layers with crops. masks and 3d rotation but can't get the correct effect

Re: 'Folding' picture

Hi Mark,

To create such an effect, add two same layers to a slide and crop them so that you have the right and the left side of the photo https://prnt.sc/12t3evo Then add a keyframe to the left layer, switch to the Animation tab, set 3D Rotation to -90, and move the layer to the middle of the slide https://prnt.sc/12t3jsc
Do the same with the right layer but set 3D Rotation to 90 instead of -90. Finally, add a keyframe in the middle of the animation effect and position the layers side to side. https://prnt.sc/12t3rbz

3 (edited by MarkFull 2021-05-14 17:40:20)

Re: 'Folding' picture

Thanks Michael

With some experimentation I have taken this quite a bit further. Helped me undestand most of the animation and mask settings!

https://access.parallels.com/to/Y6fEYJelTHq03ACnUgvCAw

Re: 'Folding' picture

Glad to help you. Good to hear you are getting closer to your perfect slideshow!

Re: 'Folding' picture

I too need this clarification.I had a lot but can't.Please suggest another way.Thanks in bunch

Thanks & Regards
Kritisen
https://m2ysafety.com/

Re: 'Folding' picture

Hi Kritisen!

If the instructions above don't work for you, please explain what exactly goes wrong to the customer support team. They'll help you create the effect.
You can submit a ticket in the Customer Support Center here: https://smartshow-software.com/support.php